Listing this truck for a friend of mine. 1968 Chevy C10 SWB Patina Truck that was featured in the Magnaflow Exhaust Sema booth in 2015. There's also a 3 page layout in the July issue of Street Truck magazine as well as a few others. Starting with an all original SWB California truck they did a complete frame off build using Porterbuilt front & rear kits. Airbag system consists of Accu Air E-Level system, Slam Specialty bags,Viair Black Compressors & a 5 gallon tank which are mounted under the raisedwood bed floor along with a Optima Battery.Baer disc brakes on all 4 corner's along with a Wilwood master cylinder. Raceline wheels 22x9 in the front & 22x10 in the rear with new tire's. Built rear end with Dutchman axle's & a locker. Fuel cell was relocated to the rear with an upgraded fuel pump. Custom made inner fenders clean up the engine compartment. Brand new LS3 mated to a 4L80 Trans. with approx. 800 miles on it. Truck was completely rewired using a EZ Wire Harness. Magnaflow custom dual exhaust which exit's through the bed in front of the rear tire's. Aluminum radiator with dual fans keep it running cool. The firewall has been shaved, cleaned up & repainted the factory color as well as the interior of the truck. The seat was redone & dynamat was installed in the cab.The truckis set up forA/C, it has the compressor, controls & vents but still needs the Vintage Air kit under the dash. Alpine stereo system with kick panel's in the front & a 10" sub in the rear running off of an I-Pod to keep the dash clean. Bed has Slosh Tubz wheel wells as well as a new wood kit installed. The exterior is original with new bumper's & side trim installed. This truck has been professionally tuned & is ready to go. Serious buyer's only you couldn't build a truck for what he's asking. The truck is being sold as-is & buyer is responsible for shipping. I could deliver it to a port for a fee if needed for export.If you have any question's shoot me an e-mail & I'll get an answer & get back to you. Thanks for looking