1980 Chevrolet Camaro Project Car: Clear Title, urrently Registered!
Fresh Rebuilt Engine/4 Speed Sagina, Hurst Shifter (Originally a V6/3speed Saginaw Manual) Front Suspension, nd Front/Rear Brakes Done.
454 (1979 Vintage) block is .030 over, resh Bores by LAMB, nd New Speed Pro Hyper Flat Tops, oly Rings, val Port Heads, ffenhauser 360 Alum Intake, 50 Carter AFB, EI with MSD Module, td/Std Crank with new 77 Bearings, ew Cam Bearings, ew Brass Freeze Plugs, ew Cloyes Tru-Roller double roller timing chain, ew Oil Pump, 0K miles on Crower BEAST cam, ew Hedman Husler Full Length Headers (2" Primaries 3.5 collectors) 2.5 inch Dual Exhaust with "44" style mufflers. New Clutch, Fresh Front end suspension rebuild with New MOOG Upper and Lower Balljoints, nergy Suspension A-Arm Bushings, nd Sub-Frame mounts already installed. New Poly Engine and Trans Mounts, ew Starter, ew Water Pump, ew Alternator, ew 3 Row Aluminum Radiator. Dual 14" Electric Fans.
New Master Cylinder,Front Brake Calipers, ront Brake Pads, ear Wheel Cylinders, ear Shoes, ll brake hardware replaced, otors and Drums Turned, earings repacked.
Gen 3 Wheels, ust needs some fresh paint.
Door Hinges rebuilt. Much of the body work has been started/done. Will need to finish some body work, aint, nd interior. I have complete front clip (fenders, kirts, ood, ront bumper, tc) Hood clearance might be an issue due to 360 Intake Manifold, won't know for sure until front end is hung. You will most likely need to add a cowl induction, r scoop of some sort.
$6000.00
First start here: (Open Headers, ngine not yet timed/nor carb adjusted) on You Tube, nder FN454