After further inspection, t appears the back half of the car is green because someone before 1987 installed OEM sheet metal on the rear passenger floor, uarters, nd trunk pan. They did an excellent job welding them in place, pulled the front seats and rear passenger carpet and inspected the weld in the middle of the passenger floor pan, hey did a great job, he welder was a professional. I included 3 pictures of this excellent work. The car is very straight with minimal rust at the lower rear glass areas and in the trunk which is rare for a Mopar. The floors and quarters are rust free too. This 69 charger is a runner and a true survivor - the engine and transmission are numbers matching. The engine retains its stock bore: 4.250. Radiator support matches the VIN. The trunk area # does not match the VIN since it was replaced as stated earlier. It also has a data plate and bill sheet. Here is a brief list of what I did to the drive train:

• I boiled out fuel tank and radiator, nstalled a new fuel pump, ebuilt the carburetor with an overhaul kit.
• Before I fired the motor up I put marvel’s mystery oil in each of the cylinders and let it soak for a couple of days.
• It had a flat cam shaft at the number two exhaust lobe so I replaced the cam with another 290 HP cam shaft with good used lifters.
• Also installed a new double roller timing chain.
• I took the cylinder heads off and good thing I did because I found four of the stock rocker arms worn down on the right side and replaced them with good stock used rocker arms.
• When the heads were off I mic'd the left side cylinder bank and bores measured 4.254 so that is how I know it retains the stock bore. Valves were not recessed, itting up high.
• Performed a leak down check on the valves in the combustion chamber with solvent. Did not need to perform lapping in the valve.
• I found the oil passage plug on the right side plugged up and the cylinder head holes were also plugged on both sides. So I cleaned out all the passages in the oil and coolant cavities.
• I pulled the oil pan out and cleaned it. Also checked the torque on rod bearings and main bearings.
• I put a new exhaust muffler on the car.
• I did a compression test on the left bank and all four cylinders (cylinders 1,3,5,7) had a compression of 145 pounds.
• Did not perform No engine work to short Block. The bottom end will have to be gone through.

  See pictures below for clarification, hey speak for them self. See pictures below for clarification.

  Shipping

  Shipping costs and arrangements are your responsibility for this car. However, will assist you on loading the car on your trailer or whatever you would like to do for shipping. Also, can deliver it to you if you live within a 150 mile radius of Fresno for a small fee. For international bidders, will only accept wire transfer.

  
  
  

  Here are the three additional pictures I mentioned of the professional job.