What we have here is a 20 foot driver, dings nicks in paint ect. Passenger side rocker dented from a low driveway. Not much rust to speak of, does have bondo dents and dings. Was a fire truck until 1969, hotrodded in the 1970's, sat from 1981 till 2010. Pretty straight, has a sunbeam tiger 4 speed,a 1959 mercury 312 with an edelbrock carb. Holley dual point distributo, fenderwell exit headers into old school thrush, sounds good. New a arm bushings,ball joints,tie rods ends could use a drag link, I drive it though. New clutch, pressure plate, throw out bearing and u joints needs 2nd gear synchro in tranny pops out downshifting, hurst competition shifter works good. Tach not wired,1970's steward warner gauges are and work. 9 " out back non posi 389 gears. Wheels are cragars sold only through J.C. Penney steel with alloy center. I've got a bunch of extra parts that go with the car. Overall it's a driver not a show car needs some work but it a true 78a courier so no bs title in hand bank transfer cash at pickup accepted 500 non refundable deposit through PayPal at end of auction. If you don't have the money don't bid don't waste my time or yours. Car can stay in my garage for a reasonable amount of time until pickup thanks happy bidding.

On Oct-18-16 at 05:16:31 PDT, seller added the following information:

Engine was rebuilt a few years ago has less than 10000 miles holds 40 psi oil pressure

On Oct-18-16 at 05:44:21 PDT, seller added the following information:

I'll post a video on utube of her running and do a walk around later today I'll put address in notes Has a couple of 1970 van seats sitting on Chevy swivel bases dash nice uncut no headliner have bows and trim original particle board sides covered in 70 with vinyl wood floor in back with original hinges and hardware for compartment behind seat have a 1957 ford bench seat also

On Oct-18-16 at 09:04:34 PDT, seller added the following information:

Posted two videos on utube go to nf78a and nf78aparts on utube first is car second is the parts I have thanks

On Oct-18-16 at 13:27:36 PDT, seller added the following information:

Video of parts finally uploaded still looking for peice of missing ranch wagon trim may or may not have it also have a factory tinted windsheild as well as door handle and window crank for drivers door and passenger arm rest. Will let the 272 4bbl intake ram horn exhaust manifolds 312 crank and bearing caps go for additional $$ will negotiate with buyer or someone else but buyer gets first dibs also not show 1 original ford rim and a complete steering column and box has a good turn signal return and is still tight thanks Norm