1930 Model A Pickup Hot Rod Project on New Brookville Frame. We set this truck up with a lot of good used parts and some new ones. This is a very solid start to a basic hot rod that can be driven. Cab is super solid Montana sheetmetal and comes with all new wood kit for all of it. Cowl top is a new Brookville part. New Brookville Grill Shell and a nice used Walker 32' Radiator for a Ford Engine Decent Bed with new Bed wood Floor included. Frame is a Brookville 2" kicked up Perimeter. We flattened the front crossmember 1 1/4". The Axle is a 4" Dropped Okie Joe. It has new Speedway Perches. Shackles. and reversed eye spring. We Split a nice Model A wishbone. Sandblasted and TIG welded bungs and installed new tie rod ends. Has really nice 37-41 Roundback spindles with new Kingpins installed. New 7/8" DOM tie rod with new Tie Rod Ends. It has a really nice pair of old chrome 46-48 Backing plates and good drums. with good brake shoe cores. Rear Axle is a 9" out of a 58' ford truck that we narrowed for early Bronco Axles. Custom 1" DOM Ladder Bars. original 32-34 rear spring mounted of rear crossmember in chassis. All the work done in this project is top notch and TIG welded. Wheels are 1940 ford 16"x 4" all the way around. Has NEW Coker 7. 00-16's on the back and 4. 50/4. 75-16's on the front. All 4 of the wheels are sandblasted and epoxy primed. Truck project sold with Bill of Sale only. Please Send message or Call with questions Jim 865-805-9381On May-05-15 at 07:12:44 PDT. seller added the following information:This pickup was set up to be run as a Hiboy or full fendered. If the truck meets the reserve I will include New Repro Pick up running boards. 30' Repro side aprons. nbsp;Repro running board brackets. Front fender brackets. and Bolt Kits. The Cab also has a good original Windshield frame and other parts that are not in photos. Please call with questions.