Sad to see this project go. Up for auction is a 1991 RX7 Convertible. Car was running up until last fall when compression was lost in one of the rotor faces. Most likely an apex seal went. The engine was completely rebuilt by T&R Racing about 1200 miles ago. Super seals were installed they warp and bend not shatter or break which saves the rotor housing in this case. The following upgrades have been installed:- Cat Back Turbo II Racing Beat exhaust- Alcohol injection-Innovate Motorsports 3781 XD-16 Wideband Standalone Gauge Kit (2 1/16 52mm) (LC-1 Sensor Bung/Plug and XD-16)- Aem true boost controller kit- Turbo II Transmission swap with rear drive axle and FULL Turbo II rear end (includingaxles)- Tial 50mm Blow off valve- Short shifter with carbon fiber knob- Racing Beat performance springs all around- Tociko struts all around- Original Mazda BBS wheels- Dual Maradyne Fans (hi flow) 1300cfm each- Haltech e6x computer with full wiring harness- Hi-flow radiator- Custom Hi -flow intercooler- Aeromotive fuel pressure regulator- Walbro 255 fuel pump- Upgraded Mazda speed seats
This car has been sitting. The sound system has been removed however NO other parts have been removed. Will make a great Tuner once the apex seal is replaced, r get all the parts you will ever needfrom one placeto restore your old rx7 convertible. 280 wheel HP when T&R Racing placed it on the dyno. Interior needs work see pics. Body is about a 6 of 10. Vinyl top needs to be replaced.
On Sep-03-15 at 13:42:31 PDT, eller added the following information:
To be clear car is not currently running...needs apex seal replacement.